Fortigate cli dhcp options how to#
Fortigate cli dhcp options software#

Fortigate cli dhcp options how to#

Fast Answers! Nearsighted Spice Donkey Nov 06, That said Was this helpful? how to configure dhcp ip address & dns in fortigate firewall We found 4 helpful replies in similar discussions. Verify your account to enable IT peers to see that you are a professional. JonosaurusRex This person is a verified professional. Get answers from your peers along with millions of IT pros who visit Spiceworks.Д«est Answer.

Fortigate cli dhcp options software#

We barely even use all the features of their imaging software but their support has been golden for the team doing image deployment. I will tell you what, the guys at Persystent know how the whole stack. Using this method got both and also made the WDS server auto select which image to boot from instead of offering a menu using dhcp option 'which do you need to boot from? I can't even find my old setup notes on this, it was so long ago and a 5 minute consult over the phone with our imaging software package we were using that uses WDS on the base. Options can be set on a server level or a scope level with the scope overriding the server IIRC so you would set up each VLAN to correspond to a different subnet and therefore they would pull from different DHCP scopes. They also validated the MTU value on all the network equipment was the same - set at The problems I experienced were. As well, they validated ports67, 68, 69 were open between vlans. In addition, they ensured the 'dhcp-snooping' configuration did not step on these broadcast going across our vlans. We had our networking crew add 'ip-helper' addresses to the networking equipment so that all dhcp broadcasts would go to the ip address for both the DHCP and WDS servers. Is there a way to have 2 option 66s or another way around with the WDS where we don't disconnect the phone server's option 66? Usually your VoIP phones or the WDS system will support an alternative DHCP option for this very reason typically they have a series of options they cycle through Option 66 is just the most common If you look at the provisioning documentation for your phones see if any alternative option is supported and switch your provisioning string to that. My guess is that it is booting the VoIP phones. The DHCP is already using option 66 to boot to the phone server.